A fly-killing device is used for pest control of flying insects, equivalent to houseflies, wasps, moths, gnats, and mosquitoes. 10 cm (four in) throughout, attached to a handle about 30 to 60 cm (1 to 2 ft) lengthy manufactured from a lightweight materials similar to wire, wood, Zap Zone plastic, or metal. The venting or perforations reduce the disruption of air currents, that are detected by an insect and allow escape, and likewise reduces air resistance, making it simpler to hit a quick-transferring goal. The flyswatter normally works by mechanically crushing the fly against a tough floor, insect zapper after the person has waited for the fly to land insect zapper someplace. However, insect zapper users also can injure or stun an airborne insect mid-flight by whipping the swatter by way of the air at an excessive pace. The abeyance of insects by use of brief horsetail staffs and fans is an ancient observe, dating again to the Egyptian pharaohs.

The earliest flyswatters have been in truth nothing greater than some sort of hanging floor connected to the end of a long stick. An early patent on a business flyswatter was issued in 1900 to Robert R. Montgomery who referred to as it a fly-killer. Montgomery sold his patent to John L. Bennett, a rich inventor and insect zapper industrialist who made additional improvements on the design. The origin of the title "flyswatter" comes from Dr. Samuel Crumbine, a member of the Kansas board of well being, who wished to lift public awareness of the well being issues attributable to flies. He was inspired by a chant at a local Topeka softball sport: "swat the ball". In a health bulletin revealed soon afterwards, he exhorted Kansans to "swat the fly". In response, a schoolteacher named Frank H. Rose created the "fly bat", a device consisting of a yardstick attached to a bit of display, which Crumbine named "the flyswatter". The fly gun (or flygun), a derivative of the flyswatter, uses a spring-loaded plastic projectile to mechanically "swat" flies.

Mounted on the projectile is a perforated circular disk, which, in accordance with promoting copy, "will not splat the fly". Several similar merchandise are bought, mostly as toys or novelty items, though some maintain their use as conventional fly swatters. Another gun-like design consists of a pair of mesh sheets spring loaded to "clap" together when a set off is pulled, squashing the fly between them. In distinction to the normal flyswatter, such a design can solely be used on an insect zapper in mid-air. A fly bottle or bug zapper glass flytrap is a passive trap for flying insects. In the Far East, it is a big bottle of clear glass with a black metal prime with a hole within the center. An odorous bait, indoor-outdoor zapper resembling items of meat, is positioned in the bottom of the bottle. Flies enter the bottle in quest of food and are then unable to escape because their phototaxis habits leads them wherever within the bottle except to the darker high the place the entry hole is.

A European fly bottle is more conical, with small ft that raise it to 1.25 cm (0.5 in), with a trough about a 2.5 cm (1 in) large and deep that runs contained in the bottle all across the central opening at the underside of the container. In use, the bottle is stood on a plate and some sugar is sprinkled on the plate to attract flies, who ultimately fly up into the bottle. The trough is stuffed with beer or vinegar, into which the flies fall and drown. In the past, the trough was sometimes stuffed with a dangerous mixture of milk, water, and arsenic or mercury chloride. Variants of these bottles are the agricultural fly traps used to combat the Mediterranean fruit fly and the olive fly, Zap Zone Defender Review which have been in use for the reason that nineteen thirties. They are smaller, without toes, and Zap Zone Defender the glass is thicker for rough out of doors utilization, insect zapper typically involving suspension in a tree or bush. Modern variations of this device are sometimes product of plastic, and will be bought in some hardware stores.